FEATURES AND BENEFITS

• Contains a specially formulated waterbourne resin 
• Provides excellent penetration 

1. Clean the roof with a high pressure water cleaner working from the ridge down to remove all moss, lichens or other contaminants. 
2. Rebed and repoiot the ridge caps where necessary and replace any cracked or broken tiles. 
3. Apply 1 liberal coat Wapol Roof Sealer. Wapol Roof Sealer may be applied to a slightly damp surface. 
4. Allow the Roof Sealer to dry for a minimum of 2 hours before over coating. 

COVERAGE
Wapol Roof Sealer will cover approximately ?m² per litre depending on the type of roof, the porosity of the substrate and tip sizes.

DRYING
Drying times are a guide only. Longer drying times may be required under cooler or humid conditions.

SIZES
20 Litres

CLEAN UP
Clean all equipment promptly with warm water with a little detergent followed by a fresh water rinse.

NOTE: Do not apply Wapol Roof Sealer if the temperature is below 10°C OR if rain is expected within 24 hours.

PRECAUTION/FIRST AID
It is recommended that normal protective clothing should be worn, including coveralls, impervious gloves and goggles. Avoid un-necessary skin contact and inhalation – use a suitable respirator if spray application is employed.
SKIN CONTACT: Wash immediately and very thoroughly with water.
EYE CONTACT: Irrigate immediately and very thoroughly with clean water for at least 15 minutes. Seek medical aid if irritation occurs and refer to MSDS for further details.

DISCLAIMER
The information contained here is given in good faith and is intended to be of assistance to users. The wide variety of surfaces and application procedures makes it impossible for us to assume any responsibility for the results obtained.